The heating system in the north has been turned on earlier these days. Radiators don't become hot to the touch as soon as they are switched on. The heat source plant ignites first, and the pipe network gradually heats up, bringing warmth to the room. Just like people need to stretch and warm up their muscles before running, wood also needs a similar process. To turn a piece of pine wood into a usable oil-impregnated sleeper, it must first be heated in a tank. Only after this heating process is it considered an oil-impregnated sleeper.
Before reaching the tank door, this piece of wood had already gone through several hands. The pine wood entered the factory, where it was peeled and sawn into a square piece. It was stacked on the ground and dried, leaving some shallow cuts on its surface. At this moment, its color is still light, and it feels light when held. But just pushing it into the tank won't allow the oil to penetrate.
So after the tank door is tightly closed, the first thing to do has nothing to do with the oil. The first step for the master is to pump out the air inside the tank. Only when the air is completely cleared can the oil come in hot. It probes in from those shallow openings. If it just seeps in by itself, it will be very slow and won't reach the bottom. Someone has to give it a little push from the outside to send it deeper, so that every part can be coated. What the person inside the tank is focusing on is this air, where it has been sent, and whether it is evenly distributed. On a piece of material, the outer ring is easy to go through, but the further you go to the center, the more effort it takes. The master is looking to see if it has reached the bottom.
The newly bought iron pot at home needs to be seasoned before its first use on the stove. Heat it up, apply oil, and let the oil penetrate into the iron. This way, it will be easier to cook dishes later and won't stick easily. The wooden piece is similar, but it needs to let the oil penetrate into the core. Just stopping at the surface doesn't count. Anyone can apply a layer of oil on the surface, but whether it can be retained depends entirely on the time spent in the pot. The difference between a piece of white square wood and a piece of oiled wooden pillar lies in this step.
Once the inside is fully soaked, the outer layer that floats on top must be collected. Once it's all collected, the material should feel dry to the touch, making it easier to stack later. As the jar gradually loses its tension, open the door and the material that comes out will be of a uniform color, shiny and oily. At this point, the wood has truly absorbed the oil. There's still one more step to go.
People who have just finished running should not sit down immediately. They need to take a walk for a while to cool down. The materials that have been taken out of the tank need to be left in the yard for a few more days, so that the absorbed oil can settle inside and outside, making them stable. Only after this period is over can they be bundled up and sent out of the factory. By then, the warm-up is complete.
Once it's in place, its job is still to support the rails. On the narrow tracks used to transport ore in the mountains, and on the short section laid by the factory itself, it's often placed under the rails. Pine is relatively soft in nature. When a train passes over it, it slightly collapses and then springs back. This process repeats throughout the year. Its color remains consistent everywhere, whether in the south or the north, on new or old tracks. When placed alongside older materials, it's hard to tell which is new. This job isn't particularly exciting. When the tank door is closed and then opened, there's nothing noticeable from the outside. Only when it's actually on the track, with trains passing over it day in and day out, do those subtle changes gradually become apparent.
Looking back at the term "warm-up", it refers to that tank. From clearing the way to stabilizing the appearance, after a trip, that light-colored square material can finally be put to use.